top of page

JEWELRY SIZE CHART

measure

BRACELET SIZE CHART

We have provided a set of steps for you to follow in order to select the appropriate size for your bracelets.​​

Here are the first few steps to follow in order to determine your bracelet size:

​

Step 1: 

Take a soft tape measure or strip of paper and wrap it around the widest part of your wrist. Note down the length of the tape or paper. If you are using a paper strip, mark your wrist size with a pen or pencil, and then use a ruler to measure the length. Make sure the starting end of the paper is at the base of the ruler and marked 0. This measurement will give you your wrist size.

bracelet-size-1_480x480.JPG
bracelet-size-2_480x480.JPG
Length (Cm)
Length (Inches)
18
7.1
17
6.7
16
6.3
15
5.9
14
5.5
19
7.5
20
7.9
21
8.3
22
8.7

step 2,:

Add one inch (2.5 centimeters) to your wrist measurement to account for the charms. Ensure that you leave enough space to fit in two fingers comfortably. If you plan to wear fewer than seven charms, adding 2 centimeters will suffice. However, if you intend to wear eight or more charms, add 3 centimeters. If you're purchasing a bangle, choose the next size up from your actual wrist measurement.

Here are some important points to keep in mind regarding bracelet sizing:

For a perfect fit, measure your wrist tightly and add 2-3 centimeters.
If you are unsure about which size to choose and prefer a tight fit, opt for the smaller size. If you prefer a looser fit, go for the larger size.
Keep in mind that a new bracelet may feel stiff initially, which can make it feel tight and uncomfortable. However, it will soften and become more flexible as you wear it.
Adding more charms to your bracelet can cause it to become tighter over time.

RING SIZE CHART

We have provided a set of steps for you to follow in order to select the appropriate size for your RING.​​

ring-size-1_480x480.webp
ring-size-2_480x480.webp

The chart provided below can be highly useful in helping you determine the appropriate ring size. To do so, you may use a measuring tape or a piece of string to measure the circumference of the finger where the ring will be worn. Once the string has formed a complete circle around the finger, mark the spot where it overlaps. This will allow you to compare the measurement with the chart provided below.

ring_size_1024x1024.png
bottom of page